New machine, two full pocket 50" diameter drum, 45" wide. 40" diameter upper feed roll. Cat C18, 765 hp. Twin Disc clutch. Eaton FX control system, remote control. 60,475 lbs operating weight, 9'11" wide, 11'1" high. New warranty. Best value on a 765hp chipper on the market.
Cat C-18, 700 hp. Platinum Cat warranty (5,000 hrs or 12/10/19). Remote controlled. Serviced, cleaned, repaired and ready for production. Call for complete condition report.
Drum chipper, Deere 6090H Tier III, 400hp, WPT clutch, bolt in belly pan, remote control, reversing fan, hydraulic swivel discharge, discharge cleanout, pegged top infeed roller. 17,700 lbs.
Cummins 600 hp, two, full pocket, 50" diameter drum. 30" width. PT Tech clutch, Cat 320EL u/c, Eaton FX control system, direct drive feed system. 70,000 lb operating weight, 132" wide, 138" high transport dims.
Deere 400hp, auto reverse, reversing fan, compressor, remote control.
Cat C18, 765hp, infeed table, remote control, end loading chute (top loading chute not included), excellent condition. Chipper gross weight 53,800lbs, weight on chipper axles 29,300 lbs.
Cat C18, 700hp. Well maintained one owner machine running daily. Engine rebuilt June, 2017 complete. Hardfaced pockets, infeed transition, infeed chain idlers, etc. Replaced original chains at 8500 hours.
Three flail, three pocket, 7/8" chip, endloading spout, dual engine, wet clutch. Cat C27 tier 2 main engine @ 875hp and Cat C13 tier 3 flail drive engine @ 440hp. One owner unit just recently shut down. Well maintained with one job supervisor and one operator since new. Call Paul at 803-920-0693 for further details.
One owner, low original hours. Cummins QSX15 - 630hp. Aux air compressor. Updated 7" shaft/ bearings, knife holders and counterknives.
Cat C27, 800 hp. Remote control. Run on clean chip operation. Well maintained
3 knife, Babbit, 3 flail, Cat 3412E, Morlift 500, compressor, discharge conveyor. One owner machine. Very well maintained, running in a four chipper rotation with three pine plantation chipping jobs.
Four knife chipper. Cat 3412E, separator, Morlift 1000 loader. Rotates in fleet on pine chipping crew.
Three flail, Cat 3412E, 1000 hp, top loading chute, aux air compressor, PT Tech clutch, hydraulic air curtain, Morlift 500, Webasto heater. Unit was a Morbark rebuild in 2012 at 9089 hours. Michigan Cat rebuilt engine complete at that time. Very nice, tidy machine.
Cat 3412E 760 hp, remote control. Run in clean chip operation. Well maintained.
Parts machine. Has 11-2005 E3412 1000hp engine with 2494 hrs separately priced at $55k.
|Call for Price||SC|
Two flail. Parts machine. Engine is sold.
|Call for Price||SC|
Three flail, three pocket, key knife, Cat 800hp mechanical rebuilt @ 13,000 hours, end loading spout, woodyard machine.